18
DAILY MAINTENANCE
ATTENTION:
All the following maintenance
and cleaning operations
that refer to the following
components that are in
contact with liquids and
therefore:
•Solution and recovery tanks
•collection box
•Solution and recovery filters
•Squeegee with their rubbers
and hoses
•Brushes
must be carried out using
gloves to protect from contact
with dangerous solutions.
RECOVERY TANK EMPTYING
AND CLEANING
1.Hold the exhaust hose (1)
placed in the rear low part of
the machine after having taken
it off from its fixing support.
2.Take off the plug (2) from
the exhaust hose acting upon
its lever (3) and empty the
recovery tank into appropriate
containers, in compliance with
the respective rules what the
liquid disposal concerns.
3.Take off suction cover (4)
after rotating the blocking
levers (5).
4.Take off the filter and filter
protection (6).
5.Rinse the inside of the tank
with a water jet through the
hole become free of the filter,
paying attention to clean
the eventual float switch (7)
(optional) and its protection
placed right under the hole.
6.Reassemble all parts.
EMPTYING AND CLEANING
OF THE COLLECTION BOX
The machine is equipped with
a collection box for the solid
dirt.
At the end of the cleaning
operation it is necessary to
empty and to clean it with a
water jet.
For the emptying and the
cleaning of the box:
1.Position the selector (10) for
the adjustment of the brushes
pressure on position P1.
2.Activate the machine (see
under paragraph “STARTING
OF THE MACHINE”)
positioning the selector (3) to
the right to choose the manual
mode (MAN).
3.Activate the push button
(17) of up/down of the
brushes base to lower the
brushes. Once it is lowered,
the brushes begin to turn.
4.Turn the key counterclock-
wise to turn off the machine.
To carry out above operations
with the electric supply on,
may cause damages to hands.
ATTENTION:
This operation must be carried
out using gloves to protect
from contact with dangerous
solutions.
ATTENTION:
5.Unblock the bar of the side
rubber after having released
the knob (1).
6.Open the bar of the side
rubber (2) as shown in the
figure.
7.Extract and carry the box by
using its handles (3).
8.Empty the box into
appropriate containers,
in compliance with the
respective rules what the
liquid disposal concerns.
9.Put the collection box back
into its position up to the end
seat.
10.Place the bar of the side
rubber (2) into its position
blocking it with the knob (1).
