13
7. Extract the support plate
(3) of the brushes by pulling
it outwards while holding its
handle. 8. Extract the brush
(4).
9. During the reassembly of
the brush (4), insert it into
the brush base from the part
where the seat is deeper
(about 40mm). The opposite
part with a depth of about
13,5mm has to look towards
the support plate.
10. Place the support plate (3)
into its position, then put back
the bar of the side rubber (2)
blocking it with the knob (1).
Use only the brushes supplied
with the machine or the ones
indicated in the paragraph
“RECOMMENDED BRUSHES”.
The use of other brushes may
produce poor cleaning results.
ATTENTION:
FLOOR CLEANING
RECOVERY TANK
Rotate the levers (2). Check
that the cover of the suction
filter (1) is correctly secured,
and that the vacuum motor
hose (3) is correctly connected
to it. Verify also that the
squeegee hose couplings (4/5)
are correctly inserted into their
seats and that the exhaust
hose plug (6) is placed in the
lower rear part of the machine.
DETERGENT SOLUTION
TANK
The capacity of the detergent
solution tank is indicated in
the technical data. Open the
screw plug placed in the left
part of the machine and fill the
detergent solution tank with
clean water at a maximum
temperature of 122°F (50°C).
Add the liquid detergent in the
percentage and conditions
shown by the manufacturer.
To avoid excessive foam
presence, use the minimum
percentage of detergent.
Screw down the plug to close
the tank.
ATTENTION:
Always use low foam
detergent. To avoid foam
presence, pour into the
recovery tank a minimum
quantity of anti-foam product.
Never use pure acid.
STARTING OF THE MACHINE
A safety device avoids the
machine’s movement if
the operator is not seated
correctly on the guiding place.
To switch on the machine:
1.Sit on the seat.
2.Turn the key switch (24)
clockwise to switch on the
machine. Automatically, the
machine gets ready in manual
(MAN) mode and in forward
movement with the quick
speed (signal lamp 22).
3.Check the charge level of
the batteries on the display (1).
4.Pressing the push button
(5) the functioning of BREAK
WASHING is chosen and
the transfer operations of
the machine are carried
out (see under paragraph
“FORWARD AND BACKWARD
MOVEMENT”). When the
signal lamp (4) is on, then
the machine is in BREAK
WASHING mode.
5.Pressing the push button
(6) the automatic (AUTO)
functioning is chosen, while
pressing the push button (3),
the functioning of the machine
becomes manual (MAN).
