Tornado 99409, Operation & Maintenance Manual

Page: 10 / 15

10
Pull Cable Connect / Disconnect Control
Insert the free end of solution cable into the valve body fitted in the solution tank. Press
and twist clockwise to secure the cable end. Similarly, press and twist counter-clockwise to
disconnect the cable end.
Solution Control
By pulling the solution control handle up, the cleaning solution is dispensed on the floor. The
solution stops once the solution control handle is released.
1
2
OFF ON
BEFORE
R E S E T
W A I T
S E C O N D S
3 0
!
P R E S S
Motor Circuit Breaker
In the event of motor getting overloaded due to improper power supply or unexpected
obstruction to the brush/drum rotation, the circuit breaker trips and protects the motor from
damage. If this happens, identify the cause, correct it and, reset the breaker after minimum of
30 seconds from tripping by pressing the circuit breaker button manually and continue working.
1
2
OFF ON
BEFORE
R E S E T
W A I T
S E C O N D S
3 0
!
P R E S S
Operating the Machine
Before the washing operation starts
Warning! Pre-sweep the floor to remove debris before using the Multiwash.
(i)
ON
3
2
1
OFF
(ii)
(Iii)
(a)
(b)
(Iv)
(a) Recommended pattern for small rooms
(b) Recommended pattern for large halls
(V)
(Vi)
1. Verify that the brushes are fitted properly.
2. Fill fresh water tank with cleaning solution.
3. Insert the plug into grounded 3-pronged outlet.
Recommended washing sequence
(i)
ON
3
2
1
OFF
(ii)
(Iii)
(a)
(b)
(Iv)
(a) Recommended pattern for small rooms
(b) Recommended pattern for large halls
(V)
(Vi)
1. Start the machine by pressing the handle release pedal and pulling
the handle back.
2. Move forward, while sparingly pulling the solution control handle (Fig-iii).
This handle should only be pulled intermittently, based on the floor type
and the amount of soil on the floor. For tiled or stone floors, apply very
little water.
3. Stop the solution discharge approximately 12 inches before the end of forward motion.
Continue to move forward up to the wall without pulling the pull handle.