7
NOTE: Give all new batteries a full charge before they
are used.
NOTE: Limit extended use of new batteries during the
first 5 operating cycles.
NOTE: Do not excessively discharge batteries.
Excessive discharge can cause polarity reversal and
complete failure of battery.
NOTE: Make sure the recovery tank is empty before
charging batteries.
• Open machine top.
• Use ammoniated window cleaner and spray
top of batteries. Use a cloth and wipe the
battery tops to remove and clean up spills.
CAUTION: BEFORE charging batteries, put
machine in a ventilated area and always
leave machine top open.
CAUTION: Only use a battery charger
designed for the machine. Failure to do so
can result in damage to the batteries. The
charger was pre set at the factory for the
configuration of your unit. If another type
of battery is installed the charger will have
to be programmed to match the batteries
that are being installed. Please see page
10 for charger programming instructions
How to Charge Batteries
• Plug the charger AC cord into a grounded
wall outlet. The charger will automatically
begin to charge the batteries.
• After batteries are charged unplug the
charger from the wall outlet.
• Close top cover of the machine.
How To Install The Squeegee
1
Put Squeegee position lever in the UP and
locked position.
2
Position the squeegee blade assembly on
the swing arm. Make sure the guide wheels
face the
rear
of the squeegee.
3
Tighten the 2 thumb screws.
4
Place the solution recovery hose over the
nozzle. Make sure it fits tight.
Summary of Contents for 99105A
Page 5: ...5 ...
