10
Installing the pad
1
Remove the center locking device located on the
underside of pad holder/brush.
2
Center the pad brush on top of the holder and
replace the locking device. The locking device
should be tight.
3
NOTE: The installation steps are the same for both pad
holder or brush.
1 Raise the brush pad by stepping on the round foot
pedal at the rear of machine. You will hear a click
when the deck is up and locked.
2 Pull the splash guard up (black splash bumper).
3 Kneel in front of the machine. Slide the pad holder/
brush under the machine and hold the pad/brush
with your hands in the 3:00 and 9:00 positions.
4 Lift the pad holder/brush up and turn slowly
clockwise until the pad/brush clutch engages the
motor mount.
5 If the pad/brush is installed correctly it will remain
on the machine. If it drops after you have turned it,
it is not installed correctly.
6 To lower the brush/pad, step down completely on
BOTH the round foot pedal and the square pedal
next to it. When fully depressed, slide your foot to
the inside to release the square pedal and SLOWLY
let the round pedal raise to the UP position.
7 Slide splash guard down around the entire brush
housing. It should be slightly above the floor.
CAUTION: Always use Tornado® plastic
clutch plate in the center of the pad
holder. Aluminum clutch plates are not
recommended for use with the EZ machines.
Installing the pad
1
Remove the center locking device
located on the underside of pad holder/
brush.
2
Center the pad brush on top of the
holder and replace the locking device.
The locking device should be tight.
How To Install The Pad Holder and Brush
The EZ uses 1 pad holder or 1 of 2 types of brushes.
Summary of Contents for 99105A
Page 5: ...5 ...
