14
How To Empty the Recovery Tank
The machine will automatically shut the vacuum motor OFF
when the recovery tank is full of dirty water.
A red light comes on at the control panel.
1
Stop the machine by releasing the Control Bar
and raising the brush drive housing.
2
Stop the solution flow.
3
Turn OFF all 3 power switches (brush motor,
vacuum motor, main power)
4
Move the machine to an area that will allow you
to empty the recovery tank into a floor drain or
basin.
5
Lower the brush deck.
6
Remove the recovery tank drain hose from the
front of the machine.
7
Raise the hose above the solution tank and
remove the plug.
8
Put the hose over a drain or in a basin and
remove the plug.
9
Empty the tank.
10
Replace the plug and tighten it.
11
Replace the hose and secure it with the clips.
Remember to fill the solution tank with fresh water before
operating the machine.
Preventative Maintenance Schedule
Daily-
1
Empty the tank and rinse the recovery tank with
clean water. Leave the tank cover open on top
to air dry.
2
Remove and clean pad or brush.
3
Clean the filter screen located at the top of the
vacuum inlet.
4
Remove the squeegee assembly, rinse and wipe
clean. Check the squeegee inlet for clogs or
debris.
5
Clean and wipe the tops of batteries with an
ammoniated window cleaner.
6
Charge the batteries as described in this
manual.
CAUTION: Avoid getting the
water into the vacuum intake
with filter screen in the recovery
tank.
Maintenance
Summary of Contents for 99105A
Page 5: ...5 ...
