Tormatic POWERSLIDE, Instruction Manual

Page: 50 / 92

PowerSlide 20
ENGLISH
2
3
 4 0
2.5 8
N L PE
4
1
 4 1
ENCODER
 4 2
1
J7
!
During operation there is a risk of fingers and hands being trapped
between the rack, pinion and casing.
The body of the electric motor can reach high temperatures during
operation.
If the encoder is installed (
 4 2
), make sure that it is connected to
the board and activate the relative parameter in advanced programming
(§ - -
EC
).
L i
The flashing light, if connected to the board, indicates that the gate
is moving.
7.1 POWER SUPPLY AND EARTHING
RISKS
F
Disconnect power to the system before making the connections and
before removing the plastic cover of the electronic board. Before
switching power on, make sure that you have replaced the plastic
cover. Do not remove the earthing wire that is connected to terminal
PE of J7 (
 4 0
-1).
1. Crimp the electric motor and system earth wires together, using
the supplied terminal (
 4 0
-2).
2. Install the M5 nut, washer and terminal supplied onto the gear
motor earth connection (
 4 0
-3). Tighten the nut.
3. Connect the phase wires and neutral to terminals L and N respec-
tively of J7 (
 4 0
-4).
 1 3
LEDs Check
STATUS MEANING
FCA §
FCC §
OPEN B
Partial opening command not active
OPEN A
Total opening command not active
FSW OP Opening photocells not engaged
FSW CL Closing photocells not engaged
STOP Stop not active
EDGE SAFE
Edge not active
ENCODER
/
Flashing when moving
Key:
= LED off = open contact
= LED on = closed contact
7. START-UP
 1 2
J7 - Power supply
PE Earth: do not remove the wire.
N Neutral
L Phase
!
Secure the mains power supply wires using the appropriate clamp
(
 4 1
-1).
4. Switch on power to the system.
7.2 LEDS CHECK
1. Move the gate to its half-travel position.
2. Check that the status of the LEDS is the same as that shown in
. If it is not, check the connections (§ ).