Instruction Manual - TORBAL DRX 5 Series
CHAPTER 5.
UNPACKING THE BALANCE AND GETTING STARTED
1. Carefully remove the scale, pan, scanner, and all of its components from the packaging and place them on a stable
base where the scale will not be affected by any mechanical vibrations or air movements.
2. After removing the pan base and the pan from their packaging, carefully install the pan base onto the scale by placing
it on the pan support located in the middle of the scale. Once the pan base has been installed, gently place the pan on
the base as shown below.
3. Connect the scanner to the scale by plugging the RJ connector into the scanner and the RS232 connector into the
scale. The RS232 port is located at the rear of the scale. Tighten the connector screw to secure the cable and prevent
it from unintentional unplugging.
7
