Instruction Manual - TORBAL AGC Series
7. To change the
OVER
limit follow the directions in Step 4 of this section and Table 8.C.4.
8. Once both limits have been set the scale will display a
TARE
command, indicating that the scale
must be tared. Before using the function place a container on the pan and press “T” to tare.
9. The scale is now ready to use. To perform check weighing place your object on the pan to check
whether the weight of the object falls within the designated range. If the weight is less than the
lower limit the scale will display the weight of the object and the command
UNDER
. If the weight
falls within the range, the
ACCEPT
command will be displayed. If the weight exceeds the upper
limit, the scale will display
OVER.
Note
: To change the limit setting press “C” and repeat Steps 1 to 7. If the same limits are used,
the scale can be tared without clearing the function and the new object can be weight-checked.
To exit check weighing and switch to a different function, press “C” to clear the current function
and then press “Function” to select a different function (follow Steps 1 through 3 from Chapter 8
on page 44).
62
