TOPP T120, Instructions For Installation And Use Manual, Page: 18 / 60

Fit the carriage on the profile "PC" and fasten the dowels "GR".
If there is room enough on at least one side of the beam, it is possible to slide the carriages, assembled in this way,
directly on the beam (Fig.17).
If neither of the two sides of the beam is free, to insert the assembled carriage remove the wheels "RC" (Fig. 18).
Insert the wheels "RC" on the beam previously installed, fitting them from the sides and turned as shown in Fig. 18.
Then fasten the carriages to the wheels and tighten the fastening screws "VC" (Fig.19).
Assembly of the wings on the carriages
Assembly the carriage fastening screws "VA" on the wings and fasten the wings to the carriages, taking care to
center the carriage assemblies on the wing (Fig. 16).
Important: to fasten the carriages to the wings and then be able to adjust them, take care to use hexagonal
screws "VA" of adequate length for the fastening system employed. Fig. 19 shows the fastening system
used for our profiles P45.
Important: at this point it is necessary to install the limit switches "FC" provisionally on the beam to stop
the wings and prevent them from slipping out and creating a hazardous condition (Fig. 19).
INSTRUCTIONS FOR INSTALLATION AND USE
EN
T120-T240
18
Fig. 17
PC
RC
RC
GR
GR
Fig. 18
RC
RC