INSTRUCTIONS FOR INSTALLATION AND USE
EN
T120-T240
Fig.
20
VA
VA
DR
DR
VA
VF1
DR
Before installing the motor unit, the transmission belt
and the belt on the beam, make sure all the final
adjustments have been made on the carriages and
wings.
Installation of electric unit and motor
Insert the three square nuts supplied on the beam and
position them as shown in Fig. 21. The electric unit will
be fastened to the nut positioned at 180mm, while the
motor unit will be fastened to the other two.
Fig.22- Remove the casing on the electric unit by
unfastening the bottom part first, pulling it manually first
in at the position indicated as no. 1 and then at the sides
no. 2-3, then slide it off no. 4, holding it slightly open with
your hands no.5.
Fasten the electric unit to the beam, first at the top Fig.
23 no. 1 and then lowering it until is snaps into place Fig.
23, no.2. Check that the head of the unit rests on the
beam and then use a 5 mm socket wrench to fasten the
screw "VE" (Fig. 24).
With the same 5 mm socket wrench, fasten the two
screws "VM" of the motor unit on the beam Fig. 25,
positioning it at height "A" listed in Tab. 2.
3.5
INSTALLATION OF ELECTRONIC UNIT, MOTOR, TRANSMISSION BELT AND BELT.
Fig.
21
180
380
450
20
Summary of Contents for T120
Page 2: ......
Page 27: ...Fig 34 Fig 35 Fig 36 30 30 INSTRUCTIONS FOR INSTALLATION AND USE EN T120 T240 27 ...
Page 59: ......
