CONTROL ELEMENTS
5- LINE GAIN
When you use a line level instrument, you
shall read the ring (-20~+20 dB). For
optimum operation, you shall set this
control in a way that the PEAK LED (16)
blinks only occasionally in order to avoid
distortion on the input channel.
6- LEVEL SET LED
This LED will help you to detect the input level
immediately. In this case, the research of the
fault will become much faster!
7- LOW-CUT Button
By pressing this button, you will activate a 75 Hz low frequency filter with a
slope of 18 dB per octave. You can use this facility to reduce the hum noise
infected by the mains power supply, or the stage rumble while using a
microphone.
9- LINE/USB Button
By pressing this button, it will switch to the USB mode, then the USB signal
can be sent to this channel or the Main Mix channel; by releasing this button,
the LINE IN inputs signal will send to the line input channels.
EQUALISER
If you turn this control up, you will boost all the frequencies above 12 kHz
(shelving filter). You will add transparency to vocals and guitar and also make
cymbals crispier.Turn the control down to cut all frequencies above 12 kHz In
such way, you can reduce sibilances of human voice or reduce the hiss of a
Tape player.
10- HI
7
6
4
9
6
8- LINE/MP3 Button
By pressing this button, it will switch to the MP3 mode, the MP3 signal can
be sent to this channel. by releasing this button,the LINE IN inputs signal will
send to the line input channels(You have to install the MP3 MOUDLE first).
There are 3-band EQ with sweepable MID on all mono input channel1-4: HI,
MID
LOW band. There are 4-band fixed frequency EQ on the stereo channel
5-16:HI, HI- MID, MID-LOW and LOW band. All bands
dB of
boost or cut.
and
provide up to 15
5
8
OPTION MODULES
U
U
S
MP3
NORMAL
NORMAL
NOTE
: Basic interface instruction.
When the player isn't connected to a USB memory equipment, the interface
is as follows:
When the player is searching for Mp3 songs, the interface is as follows:
When the player is in pause state, the interface is as follows:
When the player is in use, the interface is as follows:
In play state, press PLAY/PAUSE button to pause the player. In pause state,
press PLAY/PAUSE button to start playing.
When the unit is off, press this button and hold for about 2 or 3 seconds to
turn on the power supply of the player. Repeat the above operation, you can
turn off the power supply of the player.
ooo
NORMAL
MP3
USB ERP
S
ALL
ooo
NORMAL
MP3
USB ERP
ALL
1
1
1
66- PLAY/PAUSE
67- STOP
68- POWER
In play state, press STOP button to stop playing and the whole quantity
of Mp3 songs in the USB memory will display on the screen. In STOP
state, press the PRE/NEXT button or press the STOP button again to go
to the first songs and the player will keep in pause state, then press
down the PLAY/PAUSE button to play it.
MIX
MIX
4
5
17
6
TRIM
LEVEL
OdB 50dB MIC
35dB LINE
LOW CUT
75Hz
18dB Oct
15dB
TRIM
LEVEL
SET
SET
OdB 50dB MIC
35dB LINE
LOW CUT
75Hz
18dB Oct
15dB
TRIM
TRIM
LEVEL
LEVEL
SET
SET
OdB
OdB
50dB
50dB
MIC
MIC
35dB
35dB
LINE
LINE
LINE
USB
LINE
MP3
15dB
15dB
