Step3: Power off the keypad and disconnect pin2&3 and connect pin 1&2 of RST
together.
Step4: Turn on power again.
NOTE:
After wiring correct to PCB as per User`s Manual, Please check LM175P
operation steps as below:
1. If you only use card: Press # 123456 # 1, then read card and press #.
The Card was learned successfully.
Then you can read card directly to open or stop or close the gate.
2. If you use Password only, you need to set password first, LM175P do
not have factory default password, you need to set one yourself first.
Otherwise, the device can not work normally if you use password
mode. And please note that 123456 is not password. It is factory
default programming code.
Set password or change new password: Press # 123456 #21, then
enter new code(3-6 digitals) and press # to finish it. The new password
was set successfully.
Then you can enter the new code and press # to open or stop or close
the gate.
3. If you want to set card + password as double safety, you can get in
setting mode of card + password as below:
Press # 123456 # 3, then read card, then enter new code(3-6 digitals)
then press # to finish.
And you should set one more step as below if you use this card +
password mode.
