8
will the detector have response to iron. Because the target
numeric range for iron is 0-10.
(2) NOTCH:
Press MENU to select NOTCH, then + or
– to select the target
to be notched. The cursor above the selected target will flash.
Press NOTCH again, the target name below the cursor will
disappear. It means this target will be notched during the
detection and the detector will have no reaction to the notched
target. If you want to pick up the target notched, simply press
NOTCH again. Press + or -, the cursor will move from left or
right. If NOTCH is not pressed within about 3 seconds, the
detector will enter standby state.
Note:
1.
It is not recommended to notch all targets listed on the
LCD. Because if you notch everything, you can
’t find
anything.
2.
If you want to select the setting of DISC or SENS after
pressing NOTCH, you have to wait for about 3 seconds
until the cursor above the target goes out.
3. Press MENU to select SENS, then press + or
– to set the sensitivity.
The default level is of 6 bars.
4. Place the detector on a wooden or plastic table, then remove any
watches, rings, or metal jewelry you are wearing.
5. Adjust the search coil so the flat part points towards the ceiling.
Note:
Never test the detector on a floor inside a building. Most buildings have
metal of some kind in the floor, which might interfere with the objects
you’re testing or mask the signal completely.
