TOPEX MobiLink ISDN2GSM User`s Manual
22
The pairs of jumpers (JAN1 and JAN2 for the NT interface, JAT1 and
JAT2 for the TE interface) are located towards the right edge of the
MobiLink printed circuit board, at middle-bottom. Each pair of jumpers
is near a black rectangle (ISDN transformers). JAN1 and JAN2 are
the first pair; below them you may find the second pair, JAT1 and
JAT2 respectively. The jumpers are in horizontal position.
3.9. Power up MobiLink ISDN 2 GSM
Insert the jack of the power supply adapter (shipped in the MobiLink
package) into the PWR connector.
Then plug the adapter into the receptacle of the 230V AC mains
outlet. MobiLink ISDN 2 GSM will start working immediately. You
should see the green LED indicator (PWR) lighting up.
WARNING!
To avoid accidents or damage to the equipment, follow the
installation steps described earlier. The supply plug of the
adapter must be the last connection made. You should
NOT connect the cables for serial configuration, phone or
PBX while the MobiLink ISDN 2 GSM unit is powered.
Also, don’t take out the antennas whole MobiLink is
working.
Summary of Contents for MobiLink ISDN 2 GSM
Page 1: ...USER S MANUAL 2008...
