TOPEX MobiLink ISDN2GSM User`s Manual
17
Use ISDN cables to connect the Topex unit to your ISDN PBX (or
other ISDN terminals). Connect the cables from your corresponding
ISDN device to the MobiLink unit. More detailed information on
correct
connections can be found in
chapter 4.2. “Modes of
connection”.
For each MobiLink ISDN interface
, insert one end of the 4-wire
ISDN phone cable in the TE or NT connector of the MobiLink ISDN
2 GSM. The opposite other end of the cable must be connected to
the coresponding local or junction interface of the ISDN PBX or to
the ISDN phone. The pinout of RJ-45 connectors for TE and NT
interfaces is shown in tables at Chapter 3.9 “Pinout for connectors”
You should always select the individual NT, TE or SY connections
in accordance with chapter 4.2. „Modes of connection”. In order to
achive a good operation, you have to know the pattern of
connections required for the application (links required by the ISDN
phone exchange or telephone terminals).
Serial programming connection
– To be able to adjust
configuration of your ISDN 2 GSM interface using of the OAM
program, you must connect your equipment to a PC. The
connection is performed by means of a special cable that connects
to the „SERIAL” slot of the MobiLink device. The serial connection
is also necessary for sending and receiving SMS messages from
your PC.
Insert the jack of the power supply adapter (shipped in the
MobiLink package) into the PWR connector. Do not yet plug the
adapter into the receptacle of the 230V ac mains outlet!
Note:
If you start up MobiLink ISDN 2 GSM and the antennas
are not connected, the transmitter of the GSM module
could be damaged.
Summary of Contents for MobiLink ISDN 2 GSM
Page 1: ...USER S MANUAL 2008...
