3.
Procedures to be Completed Before the Assembly and First Operation of Your Appliance;
•
Do not place the your product under direct sunlight or within influence area of a stove, radiator, furnace,
oven, infra-red heater or air conditioner. Otherwise, the your product may perform poorly, get damaged or
become inoperable.
•
Electrical installation shall conform with the national regulations.
•
Your electrical installation shall be equipped with residual current relays and fuses to prevent the risk of
electrocution and fire.
•
In case of usage without grounding, our company shall not be responsible for any faults and damages that
might occur.
•
Place your product away from moisture, where air circulation is provided.
•
Always clean inside of your product prior to first use.
•
After placing your product, allow at least two (2) hours without moving it before starting to use.
•
If your cooler is installed in extreme cold conditions, waiting period before operation shall be at least Four
(4) hours.
•
Do not use the product in any other way than what this product is designed for.
•
Your product is designed for indoor use. Do not use your product outdoors.
•
Installation, placement, maintenance and cleaning of your product shall be performed as described in the
manual. Do not act against the manual. Warranty shall be void due to misuse in case of any damage to your
product caused by such operation.
•
Frost shall be increased for products, of which the doors are kept open or frequently open and closed, and
the appliance shall not perform the cooling operation. Thus, open the door of your product when it is
required only. Ensure that the door of your product is closed when you do not require.
•
Place the cooler on the ground and check if it is level with a spirit level. Adjust using the leg bolts in case of
any inclination to any side. Place your cooler on its place where it shall be used after completing the setting
procedure.
•
Do not change the position of the product when it is loaded or do not carry it by pushing it on its castors. Do
not push your cooler over cables or door thresholds to prevent damage to the castors even if the cooler is
empty. Never push your cooler if the ground is not level, and if there is an inclination or stairs present in the
vicinity.
Your product is set for 220 - 240 Volts and 50 Hz mains power. Use of incompatible voltage may
cause your cooler to become inoperable or fire.
In the event of a sudden power outage, unplug your product. Plug your product 20 minutes after the
interruption has ended to operate your product again. High voltage that occur when the power is
restored may cause fire or damage to your product.
