10.
Turning off Your Appliance
•
Put the food inside the appliance to a suitable place before turning off your appliance.
•
Unplug the power cord from the mains socket.
When your appliance is powered down, the ice formed inside the cooler will melt. Since there is no drainage
system in the cooler, flowing water must be taken from the lower shelf with the help of a cloth. Otherwise, the
water flowing through the cooler may damage the environment (parquet, floor, carpet, etc.). It can make the
floor slippery and cause injuries.
Perform the following if your product shall not be used for a long period
;
•
Clean your product.
At the end of the cleaning, do not close the doors before the interior of the cooler is completely dry,
the moisture remaining inside may cause darkening and corrosion.
If your product will remain in a closed environment after turning it off;
Do not cover your product with plastic material. A plastic material may cause your appliance release
odour and perspiration as it does not permeate air through it. Perspiration may cause rusting.
If you do not keep your appliance with its door open, it may release odour.
Do not unplug your product for saving power if you shall go to a short vacation or you shall not use your cooler for a
short time.
11.
Cleaning, Maintenance and Transportation of Your Appliance
11.1.
Cleaning
Unplug your cooler from the outlet before cleaning.
Before performing internal cleaning, wait until the temperature of the inner parts of the appliance increases up to
the ambient temperature.
Wear protective gloves during cleaning and maintenance. This will protect you against injuries.
Remove accessory parts from the appliance. Perform cleaning by using a soft cotton cloth and warm water.
Dry it by using a dry cotton cloth. If it is not dried, it may turn black in time.
Ensure that the inner surface is not wet or moist after cleaning.
You can reload your food two (2) hours after operating based on the type of operating specified within this manual.
External cleaning shall be performed with a cotton cloth and warm water.
Prevent cleaning water from entering the front dashboard and illumination section during cleaning.
Clean the door seal using only clean soapy water.
