WARNING!
For safety reasons the additional handle
14
should always be used.
Mount the sanding or polishing
attachment mount (Fig. C)
Mounting / removing the
additional handle (Fig. D)
Checking the battery level
To check the charging status, the battery level
indicator 3 lights up when you press the on /
off switch.
The charging status is indicated as follows:
- All 3 LEDs light up: Battery is charged
- 2 LEDs light up: Battery is partially charged
- 1 LED lights up: Battery needs to be charged
The additional handle is provided with an external
thread.
• Push the spindle lock button up 1 .
• Mount the polishing / sanding plate
13 by
turning it clockwise.
• Select the appropriate sanding or polishing
attachment.
• To remove proceed in the reverse order.
• Fix the additional handle in clockwise direction
to the left or right on the top of the tool
depending on the work.
The speed can be infinitely adjusted by varying
the pressure exerted on the trigger.
NOTE!
Ensure that the tool shaft and the tool
holder are free from dust and lightly grease
the shaft before inserting it into the chuck.
This extends the service life of the chuck and
the polishing machine.
NOTE!
Check the battery level regularly to avoid
deep discharges.
NOTE!
The polishing machine is locked if the shift
lock
4
is on the right side.
NOTE!
Change speeds only when the drill spindle
has come to a complete stop. (Risk of
damage to the gears)
Use
Switching on / off (Fig. E)
Speed selection (Fig. F)
Switching on:
• Press the On / Off switch 12 .
Switching off:
• Release the On / Off switch.
Speed selection switch in position 1:
• 1. Speed (marked as L for low speed) 0 - 2600
rpm
Speed selection switch in position 2:
• 2. Speed (marked as H for high speed) 0 -
7800 rpm
Always ensure that the speed selection
switch 2 properly locks into position 1
or 2.
