TOOLSPACE XW-1201, Manual

Page: 19 / 20

3. Attach the cordless drill/driver directly to the workpiece.
4. Press and hold the ON/OFF switch
7 )
to switch the machine on.
5. To switch the machine off, release the ON/OFF switch.
SCREWING
1. Only attach tools that are switched off to the nut/screw. Rotating tools may slip.
2. Adjust the tightening torque according to the material and screw size.
3. Place the screwdriver bit on the screw head and apply slight pressure to the tool. Switch
the tool on and screw. Release the tool release when the clutch starts slipping.
Note:
Make sure the screwdriver bit is perpendicular to the screw head. Otherwise, the screw
head and/or bit may be damaged.
DRILLING
1. Apply the power tool to the workpiece only when it is switched off. Rotating tool inserts
can slip off.
2. For drilling purposes, move the set-collar
6)
to the position “Drill” .
3. Place the point of the drill bit on the workpiece and apply pressure to the tool. Start the tool
slowly and then increase the speed gradually.
4. Make sure that the drill bit is inserted straight on the workpiece, or the drill bit may be damaged.
5. Just before the drill tip breaks through the other side of the workpiece, decrease pressure
on the tool.
LED LIGHT
When depressing the ON/OFF switch the LED light
7 )
, serving for lighting the workplace
in front of the tool clamped in the chuck, will go on automatically.
This screwdriver has an auxiliary function “torch” in addition to the LED light shining on the work
area. The torch is located at the end of the handle. Press the cover glass to turn it on/off. Attention.
Don't try to turn the ring at the end of the handle to turn on the torch. It will break off!
TIPS FOR WORKING
• Pressing excessively on the tool will not speed up the drilling. Always apply a light pressure
in a straight line with the drill bit.
• A stuck bit can be removed simply by setting the reversing switch to reverse rotation in order
to back out. However y.
• Always secure small workpieces in a vise or similar hold-down device.
• Avoid drilling in material that you suspect contains hidden nails or other things that may
cause the bit to bind.
• When driving wood screws, predrill pilot holes to make driving easier and to prevent splitting
of the workpiece. Use a drill with a diameter about 70% of the screw diameter.
• When screwing the screw on the edge of the wooden material you should predrill a pilot
hole, which will reduce the likelihood of splitting. Use a drill with a diameter about 70% of
the screw diameter.
• We recommend using self-centering screws (e.g. Torx screws, recessed head screws)
designed for reliable working.
• Be sure to use a bit that matches the screw in shape and size.
• If screws are
to tighten, try applying a small amount of washing liquid or soap as
a lubricant.