6
BEFORE EACH USE,
inspect the general condition of the tool. Check for
loose hardware, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring, and any other condition that may affect its safe operation.
AFTER USE,
wipe external surfaces of the tool with a clean cloth.
WARNING! If the supply cord of this power tool is damaged, it must be
replaced only by a qualified service technician.
1.
2.
3.
Cutting
Head
(22)
Head
Bolts (28)
Left Blade (27)
Right
Blade (24)
Center
Blade
(25)
Bushing
(26)
Unplug the tool.
Using the Hex Tool, remove the three Head Bolts (28).
The three Blades (24, 25, and 27) and the two Bushings (26)
will be loose.
Clean, replace or sharpen the blades as required.
Replace blades as a set only.Reassemble by repositioning
the Blades, and Bushings as illustrated. Replace the
Head Bolts and tighten them securely.
Test the product to be sure that it is working properly.
The Left and Right Blades (24, 27) are slotted. They can
be adjusted to change the direction of the curl of waste
material. To adjust:
a. Unplug the tool.
b. Loosen all three Head Bolts (28).
c. Make a slight adjustment to the Left or Right Blade (24, 27) as needed.
d. Tighten the Head Bolts (28).
e. Test the direction of the waste curl and repeat the steps above as needed.
1.
2.
3.
4.
5.
6.
7.
Note:
If the Head Bolts (28) are overtightened, then the Center Blade (25) will not
move freely enough, causing premature wear, or possibly preventing
the tool from operating.
If the Head Bolts are not tight enough, the tool will not make a smooth cut in the
material.
BLADE MAINTENANCE
