ToolPRO POWER CUT 25K, Instruction Manual

Page: 7 / 13

11 12
X: Duty Cycle
I1: Rated Input Current
I2: Rated Cutting Current
P1: Rated Input Power
U0: Rated Open Circuit Voltage
U1: Rated Input Voltage
U2: Rated Load Voltage
~50Hz: AC, Rated Frequency 50Hz
...V: Unit of Voltage
...A: Unit of Current
...KVA: Unit of Power
...%: Unit of Duty Cycle
...A/...V: Cutting Current and Relevent Load Voltage
...MPa: Unit of Pressure
….bar: Unit of Pressure
AS60974-1: Safety standard for the welding equipment
IP21S: Grade for the case protection. IP is the code of International Protection. 2 mean
preventing user’s finger from the dangerous parts; preventing the solid material with the
diameter no less than 12.5mm into the box. 1 means preventing water dropping vertically
which is harmless. S means water proof test is conducting while the movable part is
standstill.
H: H insulation grade
INSTALLATION (SEE FOLLOWING PICTURES)
Cutter’s Placement
• The dust, acid and erosible dirt in the air at the job site can not exceed the amount
required by the norm.
• The Cutter must be installed in the place where it can not be exposed to sun and rain. Also
it must be stored in less humid place with the temperature range at -10~+40°C.
• There should be 50cm space about for the machine to have good ventilation.
• Apparatus to exclude wind and smoke should be equipped if the inside aeration is not
sound.
APPEARANCE AND CONNECTION
Connection Sketch
Front Panel Back Panel
1. Connector for
Torch(“-”) 2. Air Pressure Meter 3. Power Indicator 4. Handle
5. Protection
Indicator 6. Current Adjusted
Knob 7. Socket(3-pins) 8. Connector for Work
piece (“+”)
9. Fan Cover 10. Gas Inlet 11. Gas lock 12. Power On/Off
Switch
13. Power cable
Entrance