Toolex MIG-200, Instruction Manual

Page: 9 / 26

9 / 26
9
UNPACKING
When unpacking, checks to make sure the
following parts are included.
Inverter welding machine with
MIG torch with Power Cord
Ground cable with Clamp
If any parts are missing or broken, please
call EACO
ELECTRIC at the number on
the cover of this manual.
Preparing Your Work Area
1. You must have a sturdy work table
that is open below the area you are
welding. Molten slag will be blown
through the work metal, and must be
able to fall away freely
2. Your work table must allow the work
metal to be firmly clamped to prevent it
accidentally falling or moving.
3. The floor and surrounding area of your
work site must not be flammable. A
clean cement floor is recommended.
The cutting process will eject molten
metal slag onto the floor, and it will
scatter for 8-10 feet or more in any
direction. Have an adequate fire
extinguisher available if needed.
ASSEMBLY
Grounding the tool:
Attach a ground wire to the screw on the
lower right of the back of the welder.
Connect the other end of the wire to an
appropriate ground, such as a steel
workbench, steel biding member or
grounding electrode.
Attach air supply:
Caution: Do not use an Argon/Mixed
pressure regulator/flow meter with CO
2
Shielding gas. To use CO
2
Shielding gas,
you must install a CO
2
Shielding gas
pressure regulator/flow meter.
1. Make sure the Flow Adjust on the
Pressure Regulator/Flow Meter is
turned
off. Then Pressure
Regulator/Flow Meter firmly onto the
cylinder valve.
2. Connect the gas air inlet (2) to your
supply CO
2
Gas supply by one air
hose (not supplied). And remember to
fasten it with coupling.
Ground
Screw
Gas inlet (2)
Heat power (3)