Toolex MIG-200, Instruction Manual

Page: 6 / 26

atmospheres containing
h. Dangerously reactive or
flammable gases, vapors, liquids,
and dust.
i. Provide adequate ventilation in
work areas to prevent
accumulation of flammable gases,
vapors, and dust. Do not apply
heat to a container that has held
an unknown substance or a
combustible
material whose
contents, when heated, can
produce flammable or explosive
vapors.
Clean and purge
containers before applying heat.
Vent closed containers, including
castings,
before preheating,
welding, or cutting.
9. Avoid overexposure to fumes and
gases. Always keep your head out of
the fumes. Do not breathe the fumes.
Use enough ventilation or exhaust, or
both, to keep fumes and gases from
your breathing zone and general area.
ℓ Where ventilation is questionable,
have a qualified technician take
an air sampling to determine the
need for corrective measures.
Use mechanical ventilation to
improve air quality. If engineering
controls are not feasible, use an
approved respirator.
ℓ
Work in a confined area only if it
is well ventilated, or while
wearing
an air-supplied
respirator.
ℓ Follow OSHA guidelines for
Permissible
Exposure Limits
(PEL’s) for various fumes and
gases.
ℓ Follow the American Conference
of
Governmental Industrial
Hygienists recommendations for
Threshold Limit Values (TLV’s)
for fumes and gases.
ℓ Have a recognized specialist in
Industrial
Hygiene or
Environmental Services check
the operation and air quality and
make recommendations for the
specific
welding or cutting
situation.
10. Always keep hoses away from
welding/cutting spot. Examine all
hoses and cables for cuts, burns, or
worn areas before each use. If any
damaged areas are found, replace the
hoses or cables immediately.
11. Read and understand all
instructions and safety precautions
as outlined in the manufacturer’s
WARNING
INHALATION HAZARD: Welding and Plasma
Cutting Produce
TOXIC FUMES.
Exposure to welding or cutting exhaust fumes can
increase the risk of developing certain cancers,
such as cancer of the larynx and lung cancer. Also,
some diseases that may be linked to exposure to
welding or plasma cutting exhaust fumes are:
a.
Early onset of Parkinson’s Disease
b. Heart disease
c. Ulcers
d. Damage to the reproductive organs
e. Inflammation of the small intestine or
stomach
f. Kidney damage
g. Respiratory diseases such as emphysema,
bronchitis, or pneumonia
Use natural or forced air ventilation and wear a
respirator approved by NIOSH to protect against
the fumes produced to reduce the risk of
developing the above illnesses.