![TOOLCRAFT 1713199 Operating Instructions Manual Download Page 35](http://html.mh-extra.com/html/toolcraft/1713199/1713199_operating-instructions-manual_1126751035.webp)
35
11. Microscope Menu Options
• To access photo or video settings, first press
to select a mode.
- An icon on the LCD display indicates that you are in Photo mode.
- An
icon on the LCD display indicates that you are in Video mode.
• Press to enter settings.
• Press
to switch between camera and general settings.
• Press or to select up or down, press OK to select an option.
• Press to exit the settings.
a) Camera
• Resolution: Change the image resolution. The higher the resolution the more memory space each image takes.
• Time Lapse:
- Frames: Set the total number of images to be taken.
- Duration: Set the interval between images taken (hh:mm:sec).
- Press to exit the settings.
- Time lapse will automatically start and the LCD will show the time lapse icon
.
- Time lapse will finish after the total number of images have been taken, by pressing OK, or pressing .
• Sharpness: Software sharpen the image on the LCD display (Hard, Normal, Soft).
b) Video
• Resolution: Switch resolution (VGA or QVGA)
c) General
• Language: Set display language
• Power Save: Set the auto shut off time if no keys are pressed (5, 10, 15) minutes.
• Frequency: Change the flicker frequency 50 Hz or 60 Hz.
• Date Stamp:
- First go to “Date/Time” and set the current time and date.
- Setting “Date/Time” will apply a date and time stamp to all your photo and video recordings.
• TV Out: Select between PAL or NTSC.
• Date/Time: Set the current date and time.
• Format SD: Erases all images on SD card / prepares new SD card for use.
• Sys. Reset: Restores all settings to factory defaults.
• Version: Indicates the installed firmware version.