33
c) Insert MicroSD Card
Do not force the card into the MicroSD card slot (A2) as this may damage microscope and the memory
card. The MicroSD memory card must be formatted before use (see section 11.c General / Format SD).
• If you wish to use the microscope untethered to a computer, you
must insert a MicroSD card (not included)
• Disconnect and turn the microscope OFF.
• Insert the MicroSD card as shown below.
See section “12. Connect to Computer” for information about connecting the microscope to a computer.
10. Operation
Do not cover the microscope when it is in use.
a) Power ON / OFF
• Press the power button to turn the microscope ON or OFF.
b) Focus the Microscope
• Place the object to be examined onto the stage (A4). If observing slides or similar, insert under the stage clips.
• While holding the coarse focus (A14) in place, release the coarse focus lock (A5).
• Rotate the coarse focus dial (A14) to lower the lens towards the object.
• Adjust the fine focus dial (A3) to bring the image into sharp focus.
It may take a few moments for the white balance to auto adjust and bring the image into focus. If there is
too much reflection from the object, consider lowering the LED brightness or turning it off completely.
c) High and Low Magnification
• Center the lens (A13) over the object.
• High magnification: Turn the fine focus dial (A3) all the way to the right, then slowly dial back until the image comes
into focus.
• Low magnification: Turn the fine focus dial (A3) all the way to the left, then slowly dial back until the image comes
into focus.
After turning the fine focus dial (A3) all the way right or left, it will take a few seconds for the LED light
balance to adjust.
