EN – V1 - P3
XX.XX
2.
Make sure the battery terminals are clean. Wire brush them if
necessary. Clamp the black load lead to the vehicle negative battery
terminal. Clamp the red load lead to the vehicle positive battery
terminal.
3.
LED display will light on and show the voltage of the battery on the
screen. Press "ENTER" to the next step.
NOTE
: If you see
HI
/
Lo
/ ---- /
Blank
appeared on the screen or
screen flickers, please refer to TROUBLESHOOTING.
4.
Please press
▲\▼
key to select the battery type of
SLI
or
SEAL
:
SLI : Standard SLI flooded batteries.
SEAL : VRLA/GEL/AGM etc sealed /MF batteries.
5.
Press "ENTER" to the next step.
6.
Please press
▲\▼ key to select the battery rating of
SAE , din,
IEC, En, CA (MCA).
7.
Press "ENTER" to the next step.
8.
Please press
▲\▼ key to input the battery capacity of CCA or CA(MCA)Κ
SAE : 200~1200 CCA
DIN : 110~670 CCA
IEC : 130~790 CCA
EN : 185~1125 CCA
CA(MCA) : 240~1440 CA(MCA)
Press "ENTER" to begin the test.
9.
Test the battery within 1 second.
10.
If the display shows CHA- (Is tested battery charged?). Please
press "ENTER" & select
▲\▼
key to choose yes or no, then
Press "ENTER" to the next step. (NBT100/NBT200 tester will judge
the tested battery status & decide to show out Step11 or not.)
11.
When the test is complete, the LED display shows the actual CCA.
One of following five results will be displayed on LED lamps:
E
ngl
is
h
