TonerRefillKits.com
RechargX™ RX161 v1
Mon - Fri 8am - 8pm ET
© 1995-2012 ReChargX™, EmptyX, TonerRefillKits and TonerRefillKits.com, the TonerRefillKits logo, the
2012.05.24
800.527.3712 or 352.343.7533 ReChargX™ and EmptyX logos are trademarks owned by TonerRefillkits, LLC. All rights reserved.
Page 3 of 10
Step 4: Plug the Toner Hopper Hole
Place the plug over the hopper hole, being sure
the plastic prong lines up with the notch on
the side of the toner hopper hole, press firmly
around the entire perimeter of the plug to make
certain the plug sits securely inside the toner
hopper hole. The white arrow in figure 5 shows
the plastic prong fitting snugly inside the notch
on the side of the toner hopper hole.
NOTE:
Do not press hard enough for the plug
to go through the hole and into the cartridge.
Step 5: Orient the Toner Cartridge
Orient the toner cartridge so the large blue
lever is on the right side and the toner vents
are facing upward, shown in figure 6.
NOTE:
It is very important you do not change the
orientation of the toner cartridge in the following
steps, unless told otherwise, or you risk causing
an unnecessary amount of toner mess.
Step 6: Locate the Waste Hopper
In this orientation the waste hopper is located
on the left side of the cartridge inside the circle
in the center of the toner cartridge, shown by
the black arrow in figure 7.
í
Figure 5:
The plug firmly in place
Figure 6:
Orient the toner cartridge
í
Figure 7:
Locate the waste hopper hole
