TonerRefillKits.com
RechargX™ RX161 v1
Mon - Fri 8am - 8pm ET
© 1995-2012 ReChargX™, EmptyX, TonerRefillKits and TonerRefillKits.com, the TonerRefillKits logo, the
2012.05.24
800.527.3712 or 352.343.7533 ReChargX™ and EmptyX logos are trademarks owned by TonerRefillkits, LLC. All rights reserved.
Page 5 of 10
Step 8: Empty the Waste Toner Hopper
NOTE:
This toner cannot be used again as
paper dust, hair, staples and other small
items can accumulate in the waste hopper.
Note:
There is no need to attempt to remove
every last bit of waste toner from the hopper,
just that which comes out easily.
Open the plastic bag, included in the ReChargX™
RX161 Toner Refill Kit, and lower the toner cartridge
so the toner hopper hole is in the bag.
Carefully pour out as much of the remaining
toner as possible (figure 12).
Shaking the toner cartridge up-and-down is
not recommended as it normally creates an
unnecessary toner mess.
If the toner stops flowing, stand the cartridge
up and then lower the toner hopper hole into
the bag (gently tapping along the side of the
cartridge helps to keep the toner flowing).
With the majority of the toner removed, seal
the bag and toss it in the garbage.
Step 9: Close the Waste Hopper
Close the waste hopper by moving the large
blue lever into the unlocked position like you
would if you were removing it from the drum
unit inside the printer, shown in figure 13.
Step 10: Clean the Area Around the Waste
Hopper Hole
After the waste toner has been removed from
the waste hopper, use the yellow/orange toner
grabber cloth to clean around the waste hopper
hole, as shown in figure 14, to lessen the risk
of a mess.
Figure 12:
Empty the waste hopper
Figure 13:
The tab in the unlocked position
Figure 14:
Clean the area around the waste hopper hole
