TonerRefillKits.com
RechargX™ RX161 v1
Mon - Fri 8am - 8pm ET
© 1995-2012 ReChargX™, EmptyX, TonerRefillKits and TonerRefillKits.com, the TonerRefillKits logo, the
2012.05.24
800.527.3712 or 352.343.7533 ReChargX™ and EmptyX logos are trademarks owned by TonerRefillkits, LLC. All rights reserved.
Page 7 of 10
Step 13: Add ReChargX™ RX161 Premium
Print Toner to the Toner Hopper
Now we will fill the toner hopper with the
ReChargX™ RX161 Premium Print toner.
To ensure the toner flows freely from the bottle
during filling, make certain the cap is screwed
tightly on the bottle, then gently rock/shake
the bottle to free up the toner that may have
settled during shipping.
Next, remove the original cap from the bottle
and replace it with the plastic dispenser spout
from the ReChargX™ RX161 Toner Refill Kit.
To make the adding of the toner to the toner
hopper as easy and dust-free as possible, tilt
the end of the cartridge with the hole in it up
at a 45 degree angle and slowly angle the
dispenser spout on the bottle of toner to meet
up with the hole, as shown in figure 17.
Tilting the bottle up a little more will start the
toner flowing into the toner hopper.
NOTE:
If at any point the toner stops flowing,
simply stand the bottle upright to loosen the
toner and start the pouring process over again
(resist temptation to squeeze the bottle as it
will make a spill or mess more likely).
Fill the hopper until it appears to be full or until
it appears toner no longer flows easily into the
hopper (any toner left in the bottle can easily
be added in the future after you have done a
considerable amount of printing).
Figure 17:
Fill the toner hopper
