Tomei Expreme Ti, User & Installation Manual

Page: 16 / 20

【INSTALLATION PROCESS】
1. Loosely install MAIN PIPE A using the included GASKET, FLANGE BOLT M10 and FLANGE NUT M10.
※ Parts used: MAIN PIPE A (①, previous page）, GASKET (④, previous page）
FLANGE BOLT M10（⑤, previous page), FLANGE NUT M10（⑥, previous page）
2. Attach the CLAMP BAND to MAIN PIPE B. Then, slide MAIN PIPE B onto MAIN PIPE A, making sure that
the spring hooks align.
※ Parts used: MAIN PIPE B (②, previous page), CLAMP BAND (⑦, previous page)
3. Attach the CLAMP BAND to the SILENCER. Then, slide the SILENCER onto MAIN PIPE B, making sure that
the spring hooks align.
※ Parts used: SILENCER（③, previous page） CLAMP BAND （⑦, previous page）
Ensure that the SILENCER is installed with the logo facing downwards.
4. Attach the SILENCER BAND RUBBER to the SILENCER BAND. Then, mount the SILENCER BAND
on to the exhaust hanger, taking care not to scratch the SILENCER.
※ Parts used: SILENCER BAND （⑨, previous page）, SILENCER BAND RUBBER （⑩, previous page）
5. Tighten down the fastenings in order from the font, ensuring sufficient clearance is achieved.
＜Torque specs.＞
FLANGE NUT M10 （⑥, previous page） [34.3~39.2N.m(3.5~4.0kgf-m)]
FLANGE NUT M8 （⑫, previous page） [19.6~28.4N.m(2.0~2.9kgf-m)]
CLAMP BAND （⑦, previous page） [25.0N.m(2.55kgf-m)]
6. Attach the SPRINGS onto MAIN PIPE A, MAIN PIPE B and the SILENCER.
CAUTION
・ Ensure sufficient clearance and correct fitment has been achieved before completely tightening
down the fastenings. In some cases, there may be insufficient clearance due to minor differences
between individual vehicles. In such a case, loosen the fastenings on the catalytic converter and
adjust the positioning until sufficient clearance is achieved before retightening the fastenings again.
・ Ensure you clean the exhaust after installation. Using the exhaust whilst there is oil or other debris
on it can cause blemishes and/or burn marks.
・ Depending on the installation and use of the exhaust, you may need to apply thermal insulation to
prevent heat damage to the surrounding components/areas.
7 Zip tie the Muffler Hanger/Strap mounts (see right)
to prevent excessive shake.
※Parts used: Zip Ties (⑯ on previous page).
8 Install the SOUND REDUCER when necessary.
※ Parts used: SOUND REDUCER (P15 ⑬), BUTTON BOLT (P15 ⑭),FLANGE NUT (P15⑮)
＜TORQUE SPECS＞
Button Bolt M6 【7.8~11.8N.m(0.8~1.2kgf-m)】
WARNING
・ Do not drive at high speeds with the SOUND REDUCER installed
as it may become damaged and/or broken.
・ Only install/uninstall the SOUND REDUCER when the exhaust is cold.
9. Re-connect the negative battery terminal.
16