Tokheim Corporation
Premier C Series Dispensers Site Preparation Manual
2-14
Form 5869 Version 3.0 July 1999 Rev. 05/12/00
Planning and Preparation
Moving the Dispenser
1.
Remove the carton and unbolt the wooden pallet from the dispenser.
2.
Remove and save the center hex-head bolt from each end of the
raceway as shown in the illustration below. These bolts are screwed
into the dispenser lift brackets.
3.
Screw a
5
/
16
-18 eyebolt (not included) securely into the top of each
lift bracket.
4.
Attach a rigid bar to the eyebolts as shown on the lifting instruction
label attached to the top of the raceway (see label below).
5.
Lift and position dispenser. Use a hoist, crane or fork lift suitable to
lift:
1,500 lbs. - 30" Dispenser
2,000 lbs. - 45" Dispenser
6.
Remove lifting hardware and install the hex-head bolts that you
removed in step 2.
WARNING
Lifting equipment can
be hazardous and
must be rated to lift
the weight of the
dispenser. Equipment
could fall and cause
severe injury or death.
Stand clear from the
dispenser when lifting
and lowering.
!
IMPORTANT!
Make sure side A of the
dispenser is positioned
onto the island per
customer specifications.
To determine side A of
the dispenser, see the
illustration on the next
page.
1-229690
