7
object, turn the disc clockwise a little. Then re-tighten the screw and re-check.
•
Camera setup settings such as shutter speed, gain, white balance type and mirror function are all done at the
Tobin Cinema factory with a special jig and software program, and cannot be altered by the user. Do not
attempt to connect anything to the camera programming port on the bottom of the camera housing as no good
can come from this.
•
In case of odd symptoms, first check the output voltage of the switching power supply. The voltage should be
15.6 volts DC.
•
The TVT may malfunction if the Ground pin on the power cord is not connected.
•
If dust accumulates on the optics it should be removed with a clean camel’s hair brush or air blower.
Fingerprints must be removed immediately with lens cleaner and lens tissue, following the instructions
included with them.
Suggested Sources of Supplies
http://www.urbanskifilm.com/