Tobii Pro Mobile Device Stand, User Manual

Page: 14 / 26

3.3 Mounting the Calibration Plate
For each participant, the calibration plate needs to be mounted before calibration and dismounted before data collection. The
calibration plate is used when calibrating a participant in Tobii Studio, Pro Lab or Eye Tracker Manager before each recording.
The mobile device you intend to use during the test should be attached to the mobile device holder before mounting the calibra-
tion plate.
To mount the calibration plate:
1. Locate the appropriate calibration plate fixing rod. The short steel rod is used when the flat holder is mounted (configura-
tions A1, A2, C1 and C2) and the long steel rod is used when the bracket holder is mounted (configurations B1, B2, D1
and D2).
2. Place the calibration plate fixing rod in the hole located below the
hand screws that hold the guide bars.
3. Place the calibration plate on top of the mobile device. Make sure
that the U-shaped cut out of the plate fits around the scene cam-
era pole.
4. Adjust the calibration plate so that the holes cut in the calibration
plate align with the two rods located next to the scene camera
pole. Align the hole at the bottom of the calibration plate with the
calibration plate fixing rod.
5. Once the holes are aligned with the rods, push the calibration plate down towards the mobile device until it is resting flat on
top.
To remove the calibration plate:
1. Carefully lift the calibration plate from its fixed position, before removing it.
10
3 Assembly Instructions
Tobii Pro Mobile Device Stand User’s manual v.1.0.8 - en-US