6
F. Install the water supply (refer to
WATER SUPPLY CONNECTION
on the following page).
G. The installing technician or electrician should complete the electrical connections by
removing the Outside Top of the unit, this panel is held in place with two screws located on
the top of the unit. Connect the unit to the available power supply either through an
attached cord and receptacle or through direct wiring by following these steps:
1.Take note of the labeling on the Power Terminal Block (
L
ine
1
,
L
ine
2
,
L
ine
3
, ).
2.Carefully identify the power source leads and attach them to the appropriate terminal
connections. Make sure all connections are clean and tight.
3.Properly ground the unit BEFORE USE by attaching a grounding wire to the Ground
Lug or Clamp provided next to the Power Terminal Block.
4.Allow enough slack in the wiring to allow for equipment to be moved about during
installation and any future servicing.
H. Check the voltage at the terminals on the Power Terminal Block with a voltmeter and
compare the values with the label listings on the side of the Oven. If the values match the
unit is ready for its INITIAL START–UP. If the readings
DO NOT
coincide you must call
the TOASTMASTER® Service Department for instructions on changing the voltage
and/or the phase.
I. Carefully position the Outside Top on the unit but do not press it into place. Position the unit
in its final operating location and refer to the appropriate INITIAL START–UP
PROCEDURE for your Smoker.
Electrical Connections
IMPORTANT: FAILURE TO FOLLOW THESE INSTRUCTIONS, FAULTY
INSTALLATION OR IMPROPER USE MAY CAUSE SEVERE EQUIPMENT
DAMAGE OR PERSONAL INJURY, AND MAY ALSO VOID ALL OR PART
OF YOUR TOASTMASTER® EQUIPMENT WARRANTY!!!
