11
11. Standby Indicator [STANDBY] (Green)
Lights while the unit is being initialized at power-
on or at reset.
Flashes when the fluorescent display is in light
shutoff mode and the light stays unlit.
Lights when the SX-2000 system is operating on
the backup power supply during power failures.
12. Input Volume Controls [INPUT 1 – 8]
Adjust the input volume of each input channel.
Rotating the control fully counterclockwise mutes
the input sound source connected to that channel
and causes the input ON/OFF indicator (28) on
the fluorescent display to turn off.
When an input channel's "Type" is set to
"Emergency" on the SX-2000 Setting software,
the input signal source is made to bypass this
Input volume control. (See the separate Setting
Software Instructions, "System Settings.")
13. Channel Keys [ON/OFF]
Turn each input channel on or off. The input
channel alternates between on and off each time
this key is pressed.
Other functions can also be assigned to each key
by using the SX-2000 Setting Software. (See the
separate Setting Software Instructions, "Event
Settings.")
When an input channel's "Type" is set to
"Emergency" on the SX-2000 Setting software,
the input signal source is made to bypass this
Channel key. (See the separate Setting Software
Instructions, "System Settings.")
14. Monitor Volume Control [MONITOR]
Adjusts the sound volume of the monitor speaker
(1).
15. Monitor ON/OFF Key [ON/OFF]
Enables or disables the audio monitor function for
the selected input channel. The monitor function
alternates between on and off each time this key
is pressed.
16. USB Port [USB]
This port is not used.
17. RUN Indicator [RUN] (Green)
Normally flashes continuously.
18. ID Switch [ID NUMBER]
Sets the SX-2000AI's device number.
.)
19. Reset Key [RESET]
Pressing this key resets the SX-2000AI.
Notes
• Resetting the SX-2000AI stops broadcasts in a
part of or all zones currently in progress via the
reset SX-2000AI.
• Do not keep pressing the key for over 1 second.
The unit cannot operate.
If the unit operation is suspended, press the
Reset key for less than one second again.
20. DIP Switch [SETTING]
Performs key lock function settings.
• Switch 1
ON:
Disables operation of the front panel input
volume controls and channel keys.
OFF: Cancels key lock status.
• Switches 2 – 8
These switches are not used.
Note
Switches 1 – 8 are set to the OFF position by
default.
SX-2000AI
