Attach the dome cover
with its projection aligned
with the mounting hole of
the camera section.
Dome cover fixing screw
(accessory)
Mounting screw
Camera direction
Horizontal rotation ± 30°
Vertical rotation between
0° and 70°
BNC
Video output
Video input
Monitor
Power supply of 12 V DC
Use the external power supply unit
of the following rating.
12 V DC, over 0.5 A
Match the polarity of the power supply
cable with that of the power input cable
(+, -) when connecting.
4. Mount the camera section to the ceiling using 2 mounting screws.
Because the mounting screws are not supplied with the camera,
prepare appropriate screws for the application. (Use screws that
are over 4 mm in nominal diameter and longer than 25 mm.)
5. Attach the dome cover to the camera section after completing all
necessary adjustments.
Insert the dome cover to the camera section, then turn it clockwise
until it locks into place.
After attaching the dome cover, fit it using a supplied dome cover
fixing screw.
When detaching the dome cover, first remove the screw, then
detach the dome cover.
Note
Do not forcefully tighten the screw. Extreme force is applied to the
screw and the screw could not be removed, as this may cause the
dome cover not to become detached.
1. Switch on the power supply of 12 V DC after completing camera
connections.
The power is supplied to the camera.
2. Connect the monitor to the Monitor Output terminal to permit a
picture to be viewed on the monitor.
Note
When the monitor output terminal is connected, a video signal
cannot be output to the video output terminal.
3. Adjust the camera angle.
Camera angle can be adjusted for up to 60°(± 30°) for horizontal
rotation, and between 0 °and 70° for vertical rotation.
6. ADJUSTMENT
Note
Since the Iris control (for sensitivity adjustment) is factory-preset to an
optimum position for general use, avoid tampering with it in normal
conditions. Turning the control unnecessarily could cause reduced
picture quality or equipment failure. When the Iris control needs to be
readjusted to match a specific subject, first set both the Adjustment
switch and the Backlight Compensation switch to the OFF position,
then adjust the control to an optimum level.
7. CONNECTIONS
Note
If the Video output is not terminated at 75
Ω
, video pictures are not
properly displayed. Make sure that the output has been terminated at
75
Ω
at the connected monitor or switcher.
