3
4
5
1
2
6
Camera outside diameter
ø105 mm
35 mm
83.5 mm
Camera mounting hole
Camera direction
Cable entry hole
ø25 mm
Cut out using
a pair of nippers.
2. GENERAL DESCRIPTION
The C-CV202-F3 Color Dome Camera is an indoor-use camera and is
equipped with a high-resolution camera and lens. It is designed to
operate on 12 V DC, which is supplied by an external power supply
unit. A fixed focal length, fixed-iris lens is built inside the camera.
3. HANDLING PRECAUTIONS
• Do not direct the camera lens to the sun or strong lighting or light
reflection.
• Do not give the camera a great shocks or vibration, as this will
damage the camera.
• It is recommended that the camera be always used in locations
where the ambient temperature ranges from -10°C to +50°C and
humidity levels of less than 90% to ensure that no condensation is
formed.
• To clean, wipe with a dry soft cloth. Never use benzene, thinner or
chemically processed towel as the unit's plastic or other parts may be
deformed or discolored.
• When dust has settled on the camera's lens, lightly clean using a
commercial camera blower or cleaning paper.
• Installing the camera cables in close proximity to fluorescent lamps
or other electrical appliances can downgrade the picture quality. In
such cases, change the wiring.
• If there is a strong electric or magnetic field near the camera, such as
television transmission antennas, motors or transformers, this may
distort or roll the monitor picture. In such cases, run the entire wiring
route through metal conduit tubing.
• Do not install the camera in locations where solvents or chemicals
are used as the camera's dome cover may be deformed or
discolored.
• Use the external power supply unit of the following rating.
12 V DC, over 0.5 A
[ bottom view ]
4. NOMENCLATURE
[ side view of the camera with a dome cover ]
(1) Power Input cable (12 V DC)
(2) Video output terminal (BNC-R jack)
(3) Monitor output terminal (RCA pin jack)
(4) Mode setting switch
(5) Iris control
(6) Dome cover
1. Detach the dome cover.
Turn the dome cover counterclockwise to detach from the camera
section.
5. INSTALLATION
2. Determine the wiring method.
2-1. Unexposed wiring
Make a cable entry hole in the ceiling.
2-2. Open wiring
Cut out the thin camera section shown below using a pair of
nippers.
3. Connect the coaxial cable to the Video output terminal, and the
power supply cable to the power input cable.
Match the polarities when connecting the power supply cable to the
power input cable.
The red cable of the power input cable is positive, while the black
one of that is negative.
Apply a self adhesive insulating tape at the power supply cable
connection with the power input cable, and BNC connection.
