10
4.3
Mounting the CBS
For mounting the CBS it is recommended to clamp the CBS in a vice. The vise must be fitted with soft
blocks to prevent damage to the Cone
To mount the CBS, the actuator will have to be actuated with low air pressure to P1, which
creates space between the adapter (170) and the CBS plate (190).
In this way the CBS can be mounted without tension, as shown in figure A
-
Clamp the CBS in the vise as shown
-
Connect the air supply to the Actuator at P1
-
Carefully place the Actuator with the adapter over the stem so that the guide ring in adapter is
not damaged
-
Make sure there is a low air pressure on P1
-
The Stem (130) is pushed out a bit
-
Use a 19 wrench to mount the Stem (130) on the CBS
-
When mounting, make sure that the adapter plate does not touch the CBS plate (Figure A) to
avoid tension on the CBS
-
Disconnect the air supply and remove the Actuator with CBS from the vise
The Actuator with CBS is now ready to mount in the Body
Summary of Contents for A1-DBS
Page 1: ...1 Instruction manual AR MA 002 E01...
Page 5: ...5 1 2 Coding of Valves...
