FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Ford Ranger PXIII
Part No.
070SB13N21W
For product warranty please refer to our website www.tjm.com.au
F-27198.docx
Page 20 of 27
04/11/2021
85.
With the assistance of another person,
carefully lift the FPS into position on the
chassis mount, then loosely secure it in place,
using supplied “ Sliding washer plate” and
M12 x 1.25 x 40mm hex bolts (4), 1/2" x Ø1-
1/4" flat washers (8) & M12 nyloc nuts (4) at
the indicated locations.
IMPORTANT: SLIDING WASHER PLATE
MUST BE ORIENTATED CORRECTLY AS
SHOWN!
REPEAT ON LHS.
86.
Align the FPS to the vehicle so that the guard
clearance is 20 to 25mm, and wing is aligned
with wheel arch.
87.
Tighten all of the fasteners to the relevant
torque settings listed on Page 2.
88.
Re-connect the indicator / park lights to the
corresponding wiring harness.
89.
Check the operation of the indicators, park
lights, and any fog lights, winches, etc to
ensure that they are functioning correctly.
90.
Use the indicated hole in the sliding washer
plate as a guide and drill an Ø8mm hole
through the mounts in both sides of the
vehicle. Keep the drill square to align with
holes in winch frame.
91.
De-burr all new edges, clean any swarf from
the areas and apply rust preventative to
exposed surfaces.
92.
Secure through the holes drilled in step 90
using M8 x 1.25 x 35mm hex screws (2), M8
x Ø24 flat washers (4) & M8 x 1.25 nyloc
nuts (2).
93.
Tension the fasteners to the specified torque
settings listed on page 1.
RHS SHOWN
CHAMFER
TO TOP
RHS SHOWN
