FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Ford Ranger PXIII
Part No.
070SB13N21W
For product warranty please refer to our website www.tjm.com.au
F-27198.docx
Page 16 of 27
04/11/2021
Steps 60 to 61 only apply if a winch is to be fitted.
Otherwise please proceed to step 62.
60.
Refer to the winch fitting instructions to fit the
winch to the chassis mount / winch frame.
61.
Further trim the bumper as necessary to
accommodate winch control box.
DO NOT INSTALL WINCH FASTENERS AT
THIS TIME.
62.
Insert the nylon plugs supplied, into the
square cut-outs for the indicator / park light
(as shown).
63.
Separate the indicator / park light body from
the backing plate.
64.
Secure the backing plate to the FPS, using the
screws provided with the light assemblies.
65.
Supporting the backing plate, refit (clip) each
indicator / park light body ensuring that an
adequate seal is achieved.
Ensure that the park light is towards
the outside of the vehicle.
66.
Repeat steps 62 to 65 for the opposite side of
the vehicle.
If an optional fog light kit has been
purchased, install it now, referring to the
fitting instructions provided with the kit.
Otherwise, follow the below steps to install
the provided fog light blanking covers.
67.
Sandwich the fog light mounting bracket
between the fog light washer plates.
68.
Position the fog light blanking cover as shown
opposite.
RHS SHOWN
