FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Ford Ranger PXIII
Part No.
070SB13N21W
For product warranty please refer to our website www.tjm.com.au
F-27198.docx
Page 13 of 27
04/11/2021
47.
With the nuts towards the center of the
vehicle, insert the inner chassis nut-plate into
the large opening in the front of the chassis
rail, ensuring the thin “leg” is positioned
towards the rear of the vehicle & touching the
bottom inside face of the chassis rail.
48.
Align the holes in the inner chassis nut-plate
with the holes in the chassis rail.
49.
Position the outer chassis support on the outer
face of the chassis rail (as shown), aligning
the respective holes with the inner chassis
nut-plate, then loosely secure it in place, using
M12 x 1.25 x 40mm hex screws (3), M12
spring washers (3) and 1/2” x Ø1
-
1/4” flat
washers (3).
50.
Repeat steps 47 to 49 for the opposite side of
the vehicle.
51.
Position the chassis mount / winch frame and
winch frame washer plate on the vehicle
chassis rail ends then loosely secure it in place
using the fasteners retained in step 23.2.
THE CHASSIS MOUNT / WINCH FRAME
SHOULD FIT AROUND THE PREVIOUSLY
TRIMMED AIR GUIDES.
RHS SHOWN
THESE TWO
HOLES ALIGN
RHS SHOWN
WASHER PLATE
CHASSIS RAIL END
RHS SHOWN
