TABLE SAW
9
GB
This table saw was partially assembled at the
factory. To assemble your machine follow the
below instructions.
Bench Extensions
1. Turn the saw and place it on the floor with
the bench facing down.
2. Align the bench extensions flush with the
saw bench.
3. Push the bench width extension onto the
sawing bench using the bolts M6
×
12 and
loosely fasten the flat washers and nuts M6.
Repeat for the opposite side.
4. Push the bench length extension onto the
saw bench using the screws M5x14 and
loosely fasten the spring washers and flat
washers.
5.
Screw the support struts to the bench
extensions with bolts M6
×
12, flat washers
and nuts M6.
6. Tighten all the bolts, screws and nuts
M6
×
12
×
10
A
M5
×
14
×
2
M6
×
12
(
×
10)
Support Strut
Outside Hole
M5
×
14
(
×
2)
ASSEMBLY
Support Legs
1. Screw the four support legs together with
the support struts onto the main frame with
the bolts M6
×
16, spring washers and flat
washers.
2. Place the rubber feet onto the support legs.
M6
×
16
×
8
B
Long /Short Centre Brace & Leg Support
1. Screw the long centre braces and the short
centre braces onto the legs using the bolts
M6
×
12, flat washers and nuts M6.
Make sure that the same braces face each
other. The long centre braces must be
mounted parallel to the operator's side of
the saw.
2.
Align the holes of two leg supports with
the holes of the rear support legs. Screw
M6
×
12, flat washers and nuts M6. Both leg
supports must be fastened to the back of
the machine.
3. Tight all the nuts and bolts.
M6
×
16
(
×
8)
65050UK00M100.indd 9
2020/5/27 9:36:12
