Tivok Energy T-HP38AB & T-HP72AB Heat Pump Installation Manual
12
CONTROLLER OPERATION
KEY
LAYOUT
On/Off
Press to switch on or off heat pump.
Mode Selection
Press to select the mode. The sequence is: cooling-
heating.
Press and hold for more than 6 seconds and heat pump
will enter defrosting mode.
During parameter setting, press to adjust parameters;
During clock and timer setting, press to choose the hour or
minute value.
Up and Down
Press them to adjust the value of water temperature, clock,
timer and parameters.
During failure checking and parameter checking, press any
of them to exit checking.
Parameter Setting
Press and hold for more than 6 seconds, you can check and
adjust the parameters.
Press the UP/DOWN key to exit operation.
If a failure occurs, press it for no more than 2 seconds, you
can check the failure code. Press it again to check failure
code if more than one occurs.
Press the UP/DOWN key to exit checking.
Clock and Timer Key
Press it to set clock and timer. Detailed operation will be
described in following pages.
During parameter setting, press it to change the rolling
direction of parameters.
