Tivok Energy T-HP38AB & T-HP72AB Heat Pump Installation Manual
10
INSTALLATION
WALL-MOUNTED
CONTROLLER
The controller is normally fixed to the side of the heat
pump, only refer to the following steps if you wish to
mount the controller on a wall that is sheltered from
moisture. Outdoor waterproof casing (supplied) can also
be installed.
1. Remove the controller from the heat pump and
unplug the controller communication cable.
2. Use a screwdriver to open the clip as picture 1,
separate the controller into 2 parts, as picture 2
below.
3. The controller should be installed at eye level on the
wall. Drill 2 x 8mm diameter holes 60mm apart as in
picture 3 for masonry walls.
4. Insert plastic wall plugs into holes and use the
tapping screw (ST4*16 D-1) to fix the back cover of
controller on the wall, as picture 4.
5. Match the front and back covers perfectly, as picture
5, make sure that it is fixed firmly on the wall.
6. Connect the communication wire securely.
j
pbq
1
60mm
8
3
