13
USB CONNECTION
The Chorus can be used with a micro-USB cable (not supplied) for connection to your
computer. You can use this cable to upgrade the firmware using Anabat Insight (see
). Firmware updates can also be performed using the SD card . See
for more information. Note that the USB connection cannot be used to download
recordings from the Chorus.
USING THE CHORUS
The Chorus is designed for fast and easy deployment. Before you start recording you must
first set your current time zone (see
). The clock will be automatically set when the
GPS obtains a signal. We also highly recommend you check for firmware updates (see
).
STEP-BY-STEP GUIDE
1.
Connect your chosen microphone/s to the appropriate side (see below): acoustic can
be on side A (latch) or B (hinge); ultrasonic on side B (hinge) only , refer to the image
below. Carefully insert the microphone jack into the microphone socket (with locking
tabs in correct alignment) until it clicks into place. Rotate the microphone clockwise
an eighth of a turn to lock the microphone in place and make a good seal (see over
page for diagram).
Do not over-tighten the connector, this will cause damage
to the microphone and recorder . It will only rotate 1/8th of a turn before
hitting the end-stop. Ensure the dust cap is properly fitted to any unused
socket to prevent water ingress. Failing to properly install the microphone
or dust cap will void warranty.
Summary of Contents for CHORUS
Page 1: ...CHORUS User Manual Version 1 0 ...
Page 7: ...7 EXTERNAL FEATURES ...
