22
Maintaining the riveting tool
• Screw socket head screw (7) into device floor
(see page 25 “Table for torque values”).
• Rub the riveting tool dry.
• Screw on the nose piece (1).
• Loosen the fixed riveting tool.
• Reconnect the compressed air supply.
• Carry out a test run without blind rivet.
Changing the jaws
The jaws are subject to mechanical wear out, and must be replaced as
soon as they start losing grip over the mandrel.
• Detach the compressed air supply.
Caution
Hazard of injury by means of bruises or cuts in case of
unchecked cutting stroke! Always detach compressed air
supply before unscrewing the nose cap (2).
Attention
Material damage! Do not let O-ring (19) get damaged. If the
O-ring has been damaged, replace immediately.
• Loosen the nose cap (2) with a wrench SW22, unscrew, and separate
carefully from the jaw case body (18).
• Loosen the jaw case (14) from the jaw case body (18) using a wrench
SW17 (hold against the jaw case body using wrench SW17).
• Carefully unscrew and lay down the jaw case (14) manually:
the jaws (15) lie loosely in the jaw case (14).
• Remove jaw pusher (16) and pressure spring (17) from the jaw case
body (18) and discard.
H
E
2
18
14
19
2
8 7
