Page 16
For technical questions, please call 1-888-380-0318.
Item 64806
Sa
FE
ty
W
E
lding
t
ip
S
tig
/ Stick
c
ontrol
S
Wir
E
Maint
E
nanc
E
29.
Set the MIG Flux / Spool Gun Switch
to MIG Flux Gun.
30. Point the Gun away from all objects.
Press and hold the Trigger until the wire feeds
through the end of the Gun two inches.
the wire liner may come out with the welding
wire. this is normal, just turn off the Welder
and push the wire liner back into the gun.
If the wire does not feed properly and
the Spool is stationary, turn OFF and
unplug the Welder and slightly tighten the
Feed Tensioner clockwise before retrying.
31. To check the wire’s drive tension, press and
hold Trigger to feed the wire against a piece of
wood from 2 to 3 inches away.
If the wire stops instead of bending,
unplug the Welder, slightly tighten the
Feed Tensioner clockwise, and try again.
If the wire bends from the feed pressure,
then the tension is set properly.
32. Turn OFF the Power Switch and unplug the
Power Cord from its electrical outlet.
33. Select a Contact Tip that is compatible with
the welding wire used. Slide the Contact
Tip over the wire and thread it clockwise into
the MIG Gun. Tighten the Contact Tip.
34. Replace the Nozzle and cut the wire
off at 1/2" from tip (1/2" stickout).
35. Close the Door. Make sure
Door is securely latched.
MIG Flux /
Spool gun Switch
Mig gun
Welding
Wire
2"
incrementally
increase tension
until
wire bends.
2–3"
nozzle
contact
tip
Mig gun
door
latch
door