Page 24
For technical questions, please call 1-888-380-0318.
Item 64806
Sa
FE
ty
W
E
lding
t
ip
S
tig
/ Stick
control
S
Wir
E
M
aint
E
nanc
E
connect Shielding gas
1. Determine which type of shielding gas would be
appropriate for the welding you will do. Refer to the
Settings Chart on the inside of the Welder door.
2. With assistance, set the cylinder (not included)
onto a cabinet or cart near the Welder
and secure the cylinder in place with two
straps (not included) to prevent tipping.
3. Remove the cylinder’s cap. Stand to the
side of the valve opening, then open the
valve briefly to blow dust and dirt from the
valve opening. Close the cylinder valve.
4. Locate the Regulator (included) and close its
valve until it is loose, then thread Regulator
onto cylinder and wrench tighten connection.
note:
When using C100 shielding gas, connect a CGA
580/320 adapter (not included) to the inlet connection
of the Regulator and wrench tighten. Thread the
adapter onto the gas cylinder and wrench tighten.
5. Attach the Gas Hose (included) to the
Regulator’s outlet and the Welder’s gas inlet.
Wrench-tighten both connections.
6. Connect the Gas Hose from the TIG Torch Cable
through the round hole in the front of the
Welder to the Gas Quick Connector inside.
The collar on the Gas Quick Connector must
click into place after attaching any hose to it.
connect power cord
1. Turn the Power Switch off before
connecting Power Cord.
2.
iMportant: change the Voltage Switch
on the back of the Welder to the
voltage of the outlet you will use.
3. If using 120VAC, connect the included adapter to
the end of the Power Cord.
If using 240VAC, do not use the adapter.
4. Plug the Power Cord into a properly
grounded and rated receptacle that matches
the plug and selected voltage.
note:
The circuit must be equipped with
delayed action-type circuit breaker or fuses.
gas Quick
connector
g
f
e
c
Briefly open valve
to clean,
then close
valve.
d
power
Switch
Voltage
Switch
240V to 120V Plug Adapter
Voltage switch and plug need to
be changed at the same time.