Page 15
For technical questions, please call 1-888-380-0318.
Item 64806
Sa
FE
ty
W
E
lding
t
ip
S
Maint
E
nanc
E
tig
/ Stick
c
ontrol
S
Wir
E
20. Make sure the welding wire is resting in the groove
of the Feed Roller, then push the wire Idler Arm
down, and swing the Feed Tensioner up to latch it
across the tip of the arm.
After the wire is held by the Tensioner,
you may release it.
note:
The tension should be 3 – 5 for solid wire and
2 – 3 for flux-cored wire. Too much force on flux-cored
wire will crush it and may cause feeding issues.
21. Pull and twist the Nozzle to remove it.
22. Unscrew the Contact Tip
counterclockwise and remove.
23. Lay the MIG Gun Cable out in a straight line so
that the welding wire moves through it easily.
Leave the cover open, so that the feed
mechanism can be observed.
iMportant
Stainless steel wire is less flexible than
other welding wire. therefore, it is more
difficult to feed through the liner and gun.
it is especially important to keep the gun cable
straight while feeding stainless steel wire.
Warning
The following steps require applying power to the Welder
with the cover open.
to prevent serious injury from fire or electric shock:
1.
do not touch anything, especially not the ground clamp,
with the gun or welding wire or an arc will be ignited.
2.
do not touch internal Welder components
while it is plugged in.
24. Turn the Power Switch off and do not touch the
Gun’s Trigger and before connecting Power Cord.
25.
iMportant: change the Voltage Switch
on the back of the Welder to the
voltage of the outlet you will use.
26. If using 120VAC, connect the included adapter to the
end of the Power Cord.
If using 240VAC, do not use the adapter.
27. Plug the Power Cord into a properly grounded
and rated receptacle that matches the plug and
selected voltage and turn the Power Switch ON.
note:
The circuit must be equipped with delayed
action-type circuit breaker or fuses.
28. Set the Mode Switch to the bottom,
wire welding
setting.
idler arm
Feed tensioner
power
Switch
Voltage
Switch
240V to 120V Plug Adapter
Voltage switch and plug need to
be changed at the same time.
nozzle
contact
tip
Mig gun